My saw has a light attached, it is u/s as it runs on those little 3amp screw in bulbs like the wardrobe ones, the saw, even when screwed down, shakes the filements to bits, and they only last a week at best. to solve the problem, I bought a magnifyer with an LED circle of lights, a magnet and optional clamp came as part of the kit, I think it was from Jessam. the magnifyer is mounted on a flexi tube and sags if stood upright so I found a length of rod that fits into my work hold-down slot, mounted an 8" length of 1" sq timber at right angles to it at the right height and the light happily hangs there right where I want it. Since it hangs down rather than across there is no restriction on the size of work you can produce. Hope this helps a little
Iggy P.S. Sorry, no picks, I am still struggling with that part of the forum.