Messages

31

General Scroll Saw Talk / My Excalibur is vibrating almost as much

« on: December 08, 2015, 11:46:26 am »

as the Sears scroll saw I bought about 30 years ago. OK, that is quite an exaggeration but it does shake my light and magnifier. The blade has some sideways wiggle. I've had it just a little over three years, use it about 10 hours per week on average, so it is probably needs an overhaul. 

Thankfully accept any helpful hints, suggestions, and at this point I will even take ridicule.

32

Pattern Requests. / Fonts that can be used for scrolling

« on: December 04, 2015, 09:04:58 pm »

Looking for fonts that would work for scrolling - the only one I have is the stencil font and that is not very appealing, at least to me. Something along the line of the GOD IS LOVE cross designed by Steve Good posted on 12/18/2014.  http://www.stevedgood.com/godislove.pdf

33

Pattern Requests. / Re: Wine holder scroll saw pattern

« on: November 25, 2015, 11:28:47 pm »

http://www.meiselwoodhobby.com/Products/ViewProduct.aspx?ID=12307&Path=2977

Thanks, Merlin.

I was looking at other pattern requests and stumbled across an answer from Merlin to someone else's request.

Thanks again,
Opi

Turning skinny lines into sawdust.

34

Pattern Requests. / Wine holder scroll saw pattern

« on: November 24, 2015, 10:45:33 pm »

I saw a wine holder on pinterest  - the message below the picture was as follows:
Found on woodworkersworkshop.com
19-W2193+-+Wine+Holder+Scroll+Saw+Pattern

The link to the picture is as follows:
https://www.pinterest.com/pin/467741111277061933/

I have searched for the pattern without success. If someone could help me find this pattern, I would be eternally grateful. Well, maybe not eternally, but for a very long time.
Thanks

Opi