Messages

1

General Scroll Saw Talk / Re: Kinked Blades

« on: February 13, 2021, 08:06:58 pm »

Looks like your blade holder needs to be adjusted but I’m not familiar with pegas holders

2

General Scroll Saw Talk / Re: looking at this saw, what do you think?

« on: December 29, 2019, 09:38:33 am »

I have a G4 I top feed no problem

3

General Scroll Saw Talk / Re: Been out of the loop but coming back

« on: December 26, 2019, 11:00:36 am »

Mikes Workshop for FD blades or Bear woods supply

4

General Scroll Saw Talk / Re: Pegas 21" Scroll Saw or Seyco ST-21 Swing Tilt Scroll Saw/ Which one?

« on: October 23, 2019, 07:35:58 pm »

Have not cut on the pegas have cut on Seyco don’t know that there is a lot of difference but I do know Seyco has the best parts and service if you need it.

5

General Scroll Saw Talk / Re: Wood Choice

« on: June 23, 2019, 09:28:59 am »

Poplar is my wood of choice it’s reasonable priced readily available nice grain and easy to paint if you so desire just my 2 cents

6

General Scroll Saw Talk / Re: HF

« on: March 29, 2019, 09:06:46 pm »

I don’t use switch on lamp my light and saw are plugged into a strip when there is power to the saw light is on rocket switches just don’t get along with sawdust

7

General Scroll Saw Talk / Re: Look for advice on a scroll saw

« on: March 10, 2019, 08:11:48 pm »

A good used dewalt 788 or 40-694 delta is probably your next step up watch Craigslist or check for specials on Amazon

8

General Scroll Saw Talk / Re: Need help with puzzles

« on: December 12, 2018, 06:43:28 pm »

I have that saw and I always use the straight up and down position you can’t be aggressive cutting puzzles  if your cutting 3/4 wood I would use a #5ur good luck

9

General Scroll Saw Talk / Re: how to fiinish puzzles (beginner questions)

« on: December 06, 2018, 06:29:24 pm »

I use beeswax and mineral oil definitely child safe cut all my 3/4 puzzles with#5 fd ur

10

General Scroll Saw Talk / Re: Pattern removal cost

« on: November 23, 2018, 05:41:38 pm »

With the shelf paper

11

General Scroll Saw Talk / Re: Hawk Saw Owners-Help!

« on: August 16, 2018, 06:33:24 pm »

Sounds like your screws holding the blades may be worn

12

General Scroll Saw Talk / Re: Excalibur Upper Arm Adjustment

« on: July 30, 2018, 06:36:24 pm »

And if all else fails call Seyco

13

General Scroll Saw Talk / Re: Pattern removal cost

« on: July 24, 2018, 06:22:10 pm »

Use the peel ang stick from walmart a lot cheaper than blue tape and you don’t have to use packing tApe

14

General Scroll Saw Talk / Re: Foot switch

« on: May 29, 2018, 08:51:17 pm »

I’m probably a Minority but I use the other type of switch and I topfeed not wrong or right just the way I do it

15

General Scroll Saw Talk / Re: RBI Hawk 226VS ?

« on: December 21, 2017, 06:38:38 pm »

My 226 has 2 positions for the bottom blade holder don't know if yours does but you might look at thst