1
General Scroll Saw Talk / Racoon Welcome
« on: November 01, 2018, 08:23:47 pm »
Here is another of Steve's patterns.
News: Had a couple issues with the forum today. 1/19/2017. I believe I have them corrected now. Let me know if you have any trouble. Thanks.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General Scroll Saw Talk / Home Sweet Home
« on: October 25, 2018, 09:23:39 pm »
Steve Good Pattern. 1" Pine, #5 Olsen skip tooth blade, 50-50 BLO
3
General Scroll Saw Talk / Burma-Shave
« on: September 29, 2018, 10:43:31 pm »
1/4" floor underlay.
4
General Scroll Saw Talk / Steve Good's Hot Rod Clock
« on: September 29, 2018, 06:06:18 pm »
Car cut from cheap pine using a #7 skip tooth Olsen or is it Olson blade? I forget if he's Swede or Norwegian. That was for the outside cut. All inside cuts were #3 Pegas mg blade. The base is Poplar from an old discarded dresser drawer. Finish is Minwax stains with a couple of coats of gloss poly in a rattle can.
5
General Scroll Saw Talk / Steve Good's Camaro
« on: September 21, 2018, 02:41:54 pm »
Recently cut on 3/4" Polar, #7 Pegas MG
6
General Scroll Saw Talk / Texasa Woodworking Show
« on: April 15, 2018, 03:57:48 pm »
Steve, I just read your daily post and it appears you have had a great time at the show. The pictures are interesting too. Unfortunately Denver has not had a similar show for quite some time. So it's good to see others enjoy them.
7
Introduce Yourself. / Newbie from Colorado
« on: October 29, 2016, 06:04:22 pm »
I'm a new scroller. I recently acquired two older Hawks, a 220VS and a 14" Hawk. I'm 78, retired and my interests are amateur machining, pen turning and riding my CanAm tryke. I still repair clocks full time. Don't know what I can contribute but love to learn.
Pages: [1]
