871
General Scroll Saw Talk / Re: Blades
« on: July 18, 2011, 11:03:06 pm »
I used a putty knife to take the tap off, as long as the pty knife is sharp ,
gene
gene
News: Had a couple issues with the forum today. 1/19/2017. I believe I have them corrected now. Let me know if you have any trouble. Thanks.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
872
General Scroll Saw Talk / Re: Blades
« on: July 18, 2011, 12:21:43 pm »
I will get a photo of the picture as soon as possible.
gene
gene
874
General Scroll Saw Talk / Re: Blades
« on: July 17, 2011, 01:57:27 am »
Can you spray the mineral spirits on top of the pattern or if you put tape over the pattern you just spay it over that and no putty knife is needed?
gene
gene
875
General Scroll Saw Talk / Re: Blades
« on: July 16, 2011, 11:44:14 pm »
I sure do thank you all for the advice. I tryed putting the tape on the bottom. When I went to take it off, I had to use a putty knife. Will a heat gun help take the tape off and the patteren on the front?
876
Introduce Yourself. / Re: Hello from Huntsville, Tx.
« on: July 16, 2011, 11:37:06 pm »
Hi James, welcome aboard. I'm Gene from Iowa.
878
Get togethers, shows and swap meets / Re: Iowa
« on: July 15, 2011, 10:58:21 pm »
Hi Guys,
I'm from Fort Dodge. Wish we all lived a little closer.
gene
I'm from Fort Dodge. Wish we all lived a little closer.
gene
879
General Scroll Saw Talk / Re: Wildwood designs
« on: July 15, 2011, 12:39:00 pm »
How long did it take to make Mike?
genevg
genevg
880
General Scroll Saw Talk / Re: Wildwood designs
« on: July 15, 2011, 10:34:51 am »
I have been doing this for about 1 1/2 years now. What I had to do is start with simple ones to get use to my saw. Then through time I worked up to the hard cuts. I still do not feel I am ready for a project like the tower. But good luck if you try it.
genevg
genevg
881
Introduce Yourself. / Re: New Members
« on: July 14, 2011, 11:54:43 pm »
Wewlcome George and Terry, I'm Gene from Iowa
genevg
genevg
882
General Scroll Saw Talk / Re: New Members
« on: July 14, 2011, 11:47:29 pm »
some day I will learn to spell> 
genevg
genevg
883
General Scroll Saw Talk / Re: New Members
« on: July 14, 2011, 11:46:22 pm »
Yes in deadee, welcome. I found out there are a lot of good people out there to help, so please introduce yourself and let the saw dust fly.
genevg
genevg
884
General Scroll Saw Talk / Re: Blades
« on: July 14, 2011, 11:43:50 pm »
Thank you all for the help. I will give it a try in the morning.
genevg
genevg
885
General Scroll Saw Talk / Blades
« on: July 14, 2011, 04:18:20 pm »
I need some information on lubercating blades. I have been working with some Oak & Red Oak, and the blades get really hot. How do I lub the blade while makeing saw dust with hard lumber?
genevg
genevg
