Scrollsaw Workshop Community -Please register to enable posting.

General Category => Tutorials, Techniques and Tips => Topic started by: Buzz on December 04, 2020, 12:18:52 am

Title: Trying to cut out a middle piece on old Scroll saw.
Post by: Buzz on December 04, 2020, 12:18:52 am

I have a Protech 3303 the upper arm does not raise up.  I am trying to do the Santa pattern Steve put out the other day.  I didn't know if there are any tips or tricks in getting the blade in the holes in the center of the big board 10" I have bent the blade trying to get it in the holes.  Thanks in advance for any help. 

Title: Re: Trying to cut out a middle piece on old Scroll saw.
Post by: KCSteve on December 04, 2020, 09:00:45 am

It's better to bend the blade to the side instead of front / back, but there are still limits.

How easy/hard is it to clamp the blade top & bottom?  You might have to put the blade through the wood and then clamp it.  Might have to use a little blue tape to keep the  blade from slipping out until you get it clamped.

Not having an arm that lifts is a definite restriction.  Doesn't mean you can't do things, just means it's harder.  But therefore more rewarding when you do succeed.

Good luck!

KCSteve :->