Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: tinker1 on January 25, 2018, 07:33:56 am

Title: Steve's what the heck is it? project
Post by: tinker1 on January 25, 2018, 07:33:56 am

my guess is its a electric blade leveler

Title: Re: Steve's what the heck is it? project
Post by: jscott2 on January 25, 2018, 09:51:10 am

I think you are correct but it has an LED so it must be an electronic blade leveler.   ;)
Jim

Title: Re: Steve's what the heck is it? project
Post by: dirtrider73068 on January 25, 2018, 05:13:00 pm

One of two things, its either to check that your square is square if it is the led lights up. Or tells you the blade in the scroll saw is 90 to the table if its the led lights up, would my guesses.

Title: Re: Steve's what the heck is it? project
Post by: justlarry on January 25, 2018, 07:00:32 pm

Blade square to table checker.  When each bolt head touches blade circuit is complete and the led comes on.  Level bolt heads with the square and give it the ole smoke test.

Larry

Title: Re: Steve's what the heck is it? project
Post by: GLC on January 26, 2018, 11:16:23 am

Steve, I just wanted to take the opportunity to say thanks for your thoughtfulness and ingenuity.  As a visually and physically impaired newbie I wanted to recognize your effort for those who could use a helping hand. 

GLC   

Title: Re: Steve's what the heck is it? project
Post by: scrappile on January 26, 2018, 03:42:22 pm

Did anyone notice he had some kind of crank mechanism attached to his Seyco, to move the tilt the head?  I want to know more about that.

Title: Re: Steve's what the heck is it? project
Post by: rjweb66 on January 26, 2018, 09:04:14 pm

Yes I saw that crank and believe you are right that’s its for the tilting head, I wonder if I could reg that up on my jet, RJ