Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: rickther on November 17, 2017, 10:15:21 am

Title: portrait
Post by: rickther on November 17, 2017, 10:15:21 am

I am wondering if someone could convert this photo into a pattern. it is for our local santa.
thank you,    rick

Title: Re: portrait
Post by: Joleet on November 17, 2017, 04:15:27 pm

Rick.... This pix is very small and very hard to design however, I gave it a try. Hope it helps.....Ron

Title: Re: portrait
Post by: Joleet on November 17, 2017, 04:18:58 pm

Rick...I also made another one with a different take on the Santa suit.....Ron

Title: Re: portrait
Post by: Shufflex on November 18, 2017, 09:20:38 am

My vote would be for the second one, but I'm new to all of this so my vote doesn't count  ???

Title: Re: portrait
Post by: Joleet on November 18, 2017, 03:57:52 pm

Shufflex....I think your right. With a red backer just behind the suit and hat would be just the right amount of red.  #1 would be too much... Your vote always counts on this site....Ron

Title: Re: portrait
Post by: Shufflex on November 18, 2017, 04:41:42 pm

I agree Ron, I think a red backer would complete it and give a great look.

Title: Re: portrait
Post by: eburk on November 18, 2017, 05:08:30 pm

I agree with both of you. Nice job on this pattern.

Title: Re: portrait
Post by: rickther on November 19, 2017, 10:48:29 am

Thank you Joleet, I think it is a fine pattern and I will try and post it when I am done, again thank you.    Rick

Title: Re: portrait
Post by: Joleet on November 20, 2017, 12:06:49 pm

Rick...Your very welcome,  any time....Ron ;)