Scrollsaw Workshop Community -Please register to enable posting.
General Category => Ask Steve a question. => Topic started by: Maximzodal on January 29, 2017, 12:42:38 pm
-
I bought an old Hegner Multimax 2 and the blade is right up against the left side of the hole in the table. The hole is chewed so this has been a problem before I bought the saw. There isn't enough movement of the blade clamps to remedy the problem. Is there a way to adjust the table or arms so the blade can be away from the left side?
Thanks
-
Call Advance3d Machinery. They are US distributers for Hegners and good folks.