Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: Toneman on February 27, 2012, 05:31:08 pm

Title: Pattern Paper and Tape Problem
Post by: Toneman on February 27, 2012, 05:31:08 pm

For some reason today, when I made a cut, the paper/tape would not clear the cut and I could not follow the line without stopping and brushing off with my finger! I am new to scrolling and wandered if I was doing something wrong or had a problem with saw or blade adjustment? Was speed too slow or blade worn out or tube not blowing hard enough or??? I was using blue painters tape and 3M77 adhesive and #2 blade on 1/4" birch. I did not seem to have problem yesterday using #5 blade on 3/4 hard pine. Any feedback would be greatly appreciated.

Tony,aka,Toneman

Title: Re: Pattern Paper and Tape Problem
Post by: dgman on February 27, 2012, 05:46:02 pm

Hey Tony, First off, What kind of saw are you using? was you speed set at the same as yesterday? It sounds like either the air blower tube was not directing the air to the blade or it was not blowing enough. If the speed was reduced, it's possible that it does not blow enough air at that speed. More than likely, the tube was not directed correctly.

Title: Re: Pattern Paper and Tape Problem
Post by: Toneman on February 27, 2012, 06:01:19 pm

I am using an Ex 21 and yesterday I had saw speed set 100% due to hard pine and thickness, so, maybe speed is my problem!?

Tony

Title: Re: Pattern Paper and Tape Problem
Post by: dgman on February 27, 2012, 08:17:52 pm

Is your air tube pointed to the base of the blade?

Title: Re: Pattern Paper and Tape Problem
Post by: Toneman on February 27, 2012, 11:36:56 pm

Yes, tube is pointing to contact of blade and pattern.

Title: Re: Pattern Paper and Tape Problem
Post by: GrayBeard on March 01, 2012, 09:24:24 am

Sounds maybe like a leak in the bellows....

~~~GB~~~