Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: geneVG on February 11, 2012, 01:24:07 pm

Title: Need a pattern
Post by: geneVG on February 11, 2012, 01:24:07 pm

I would like some help.  I need a 11 x 81/2 pattern that says "Gene's Little Wood Shop".  And in the middle have a scroll saw.  I need it to set on my tables when I am at a show so people know the name of my shop.  Any help would be nice.  And thank you in advance.

gene

Title: Re: Need a pattern
Post by: jason03151980 on February 11, 2012, 11:05:54 pm

heres 2 i tried one caps and other small case hope they help

Title: Re: Need a pattern
Post by: smitty0312 on February 12, 2012, 08:11:26 am

Here's my try. Enjoy. Nice patterns too Jason.

Title: Re: Need a pattern
Post by: jason03151980 on February 12, 2012, 11:10:49 am

Quote from: smitty0312 on February 12, 2012, 08:11:26 am

Here's my try. Enjoy. Nice patterns too Jason.

nice ones smitty

Title: Re: Need a pattern
Post by: geneVG on February 13, 2012, 08:28:20 am

Thanks guys,they are all great, I think I will make one of each since I can't pick which on I like for I like all three.  I have four tables and I will have three signs.  Thanks again.

gene

Title: Re: Need a pattern
Post by: geneVG on February 13, 2012, 07:45:16 pm

What happen to the one in red? 

gene

Title: Re: Need a pattern
Post by: TheMelster on February 13, 2012, 09:41:25 pm

Gene, sorry that pattern had island in it.... letters would fall out. I'm back to the drawing board.

Title: Re: Need a pattern
Post by: TheMelster on February 13, 2012, 10:45:30 pm

 :) If at 1st you don't succeed, try try try again.... Give this a Go.