Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: golfman on January 16, 2012, 06:50:22 pm
-
I have learned a lot from this family in the last eight months. Last week I finished the Effiel Tower from plans from Wildwood and will post a pic as soon as I figure out how. Today I tried to cut the big cat from Steve's catalog and failed miserably. I stacked three 1/8 bb and used a #3 FD SR blade. What is a good way to cut portraits? Thank you for any help you can give me
-
Hello I like useing 2/0 r olsen blades they are the smallest reverse blade I have found u can the puzzle blades the smaller the more detail u can put in the pice if you take time to learn the spiral blades work to it is just taken your time that works the best and use the smallist drill bit u can I use num 71 and 63 that is awsome of your lastproject hope to see ur pics I got it on my list to make one I am building the grandfather clock by wildwood give it a try its alot of cuting
-
The best thing for the "Big Cats" is the FD New Spiral #2/0....
That is my blade of choice for ALL portrait work...
~~~GB~~~
-
Have you ever cut with a spiral blade before this portrait?
If I remember the Effiel Tower project you refer to, that isn't a simple piece. My best advise is to take your time and do portraits one cut at a time.
Also. Many portraits look fine even if you don't follow the pattern lines exactly. Look at the back side as you cut, when you can't see the pattern the piece looks a bit better. I have made some serious errors in some portraits that no one but me and maybe the pattern designer would be able to spot. You might be being to hard on your self.
-
Msn is right, I have thrown out more than one project I didn't think was any good. My Bride is now checking the firewood pile when she comes into the shop. Four Christmas presents were "rescued" by her. . :)
-
Don't be so hard on yourself, if a piece drops out chances are no one will notice only you. If in doubt hold it up and ask someone their opinion then decided if you did good or bad.
Marg
-
Get some practice with a spiral blade. I cut most of my portraits with a spiral 2/0. I have also used a 2/0, 1 and 2 reverse tooth but be careful with a reverse tooth on delicate areas. I've snapped more than one delicate area doing this. I have a tough time with the puzzlers blade. It seems to have a mind of it's own.
-
Thank all of you I will be getting some spiral blades from Mike and will be practicing and yes I am too hard on my self but learning more from this group of helpful people.
-
Here's what I've found works for me with spirals. I thinks others here will agree with this:
1. Good blade tension
2. Fast saw speed (I crank mine all the way up)
3. Cut slowly. Every movement of your piece is going to remove some wood, so be very deliberate in how you move it.
4. Learn to recognise when a blade is getting dull. Sharper blades are easier to control. If your having to fight to keep it cutting where you want, it's probably time to change it. I went through 3 dozen blades on a recent project.
5. Practice, practice, practice. As you get used to using spirals, you'll be able to go a little faster, but concentrate on precision instead of speed.
Hope this helps! Good luck!