Scrollsaw Workshop Community -Please register to enable posting.
General Category => Intarsia => Topic started by: justmike on December 27, 2011, 07:42:26 am
-
I am putting a finish on my first intarsia using tung oil. I put on a coat of sealer first but it seems the oil is just soaking into the wood. Am i just being impatient or should keep adding oil? Any suggestion?
-
Hello friend. Tung oil will just continue to soak into the wood. It is not a high build finish like poly or lacquer. Tung oil gives a soft hand rubbed look.
-
It varies with different woods. Softwoods like cedar will soak it up a lot where hardwoods like oak will need less coats. I use an acrylic spray I get at Walmart to finish my intarsia pieces. Yes you can spray it over dried tung oil or dried lacquer.
-
I don't use Tung oil on my Intarsias. I put on about five layers of Deft, Satin spray and they turn out just the way I like them.
-
Thank you for all the responses, is the Deft satin spray sold at home depot, lowes or wal-mart? I'm not familiar with it but I really like the lhe looks. I'll look on the net. Thanks again.
-
You can get Deft Satin spray at both Lowe's and Home depot. I've never tried finding it at wal-mart.
Deft has a Poly spray out now, but I've never tried it yet. The Deft I use is in a Blue and White can and it's called Clear Wood Finish, Satin. It's a clear Lacquer that doesn't turn White woods yellow. You can re-coat in a half hour, so putting on multi coats goes fast.
-
I always do two or three coats of wipe on urethane, about 8 hours in between coats, then 3 to 5 coats of a thick glaze spray, the urethane brings out the rich color in the wood, and the spray gives it a reflective glass like feel and look. Hope this helps
Ben