Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: navymancdf on November 29, 2011, 05:40:49 pm

Title: Need help with first chirstmas ornament
Post by: navymancdf on November 29, 2011, 05:40:49 pm

I was wondering if someone could help me i would like to make my daughter her first christmas ornament but cant figure out where to start i know i want her name in it (ELIANA)  with the year but that were i am stuck any help be greatly appreciated thank you.

corey

Title: Re: Need help with first chirstmas ornament
Post by: Russ C on November 29, 2011, 06:34:28 pm

How about this. Hope it works, it is around four inches in diameter.  :)

Title: Re: Need help with first chirstmas ornament
Post by: tux_linux on November 29, 2011, 06:44:26 pm

cut it full size! Small stuff is for p... ;D

For Ornaments like this you'll have to play with Wordart. You should get the OpenOffice Suite (http://www.openoffice.org), it has a pretty neat tool called "draw" in there. I use it often, even if it's just for resizing patterns and saving them as PDF (to make sure I can reprint the pattern).

Title: Re: Need help with first chirstmas ornament
Post by: navymancdf on November 29, 2011, 06:53:15 pm

I like it Russ thank you very much

Corey

Title: Re: Need help with first chirstmas ornament
Post by: Russ C on November 29, 2011, 07:02:10 pm

@Torsten no thanks, I have CorelDRAW Graphics Suite X5. Just not use to exporting from it for the web. I am use to creating and printing patterns for myself. Just had to figure out how to make it smaller when I exported it. No biggy.   8)

Title: Re: Need help with first chirstmas ornament
Post by: tux_linux on November 29, 2011, 07:03:41 pm

now it's too small. the other picture had a much better quality.