Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: pieter on September 13, 2011, 10:22:55 pm

Title: Hand Holding Quill
Post by: pieter on September 13, 2011, 10:22:55 pm

I am looking for simple a basic scroll saw pattern of a hand holding a quill.  I intend to cut it into the front of one of Steve's Busness Card Holders for my daughter.

Pieter

Title: Re: Hand Holding Quill
Post by: Chachi on September 14, 2011, 11:41:55 am

I hope this is what your looking for and can use it.

Title: Re: Hand Holding Quill
Post by: pieter on September 14, 2011, 02:16:12 pm

Thank you Chachi; just what I was looking for and yes I can work with it to fit the card holder.  Again thanks!

Pieter

Title: Re: Hand Holding Quill
Post by: Gabby on September 15, 2011, 02:20:52 am

Good job Chachi, the nice thing about it you could cut it as a silhouette or just cut the lines.
Gabby