Scrollsaw Workshop Community -Please register to enable posting.
General Category => Pattern Requests. => Topic started by: bigred7469 on August 31, 2011, 11:45:22 am
-
I was wondering how hard it would be to put the attachment into a cicrle and make it into a Ornament? Also what is the rule of thumb on Ornaments 1/8 or 1/4 I can see up and downs for both sizes. Thanks!!
Red
-
Well I cut the ornaments from both thicknesses...if there is enough 'cut out' the 1/4" will not be too heavy.
RE: your pattern...One of our Esteemed Designers might be able to do something but you need to post a larger image for them to work with. Maybe do one of each insignia would be better...
~~~GB~~~
-
ouh - that one is too small.
Check PM, I'll give it a try.
-
Hi Red, Having 3 anchors in 1 ornament will be a bit delicate to cut, i have done just 1 and that will be a bit tricky.....Paul
-
I talked to him, figured out that these are US Navy UNiform Insignias and found some good pictures to start with -
http://www.goatlocker.org/resources/cpo/downloads/clipart.htm
Come on - show him what you can make out of these! (all 4!)
-
Thanks grampa. I'll try to cut it this week. I'll post a pic if it turns out.
Red
-
Hi Red, Having 3 anchors in 1 ornament will be a bit delicate to cut, i have done just 1 and that will be a bit tricky.....Paul
How did you make that patteren? I'm going to give this one a try and if it works out I'll make Senior Chief and Master Chief ones as well.
Red