Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: GrayBeard on July 12, 2011, 10:50:30 am
-
http://www.ptreeusa.com/edirect_071211.htm (http://www.ptreeusa.com/edirect_071211.htm)
I think it could be adapted to fit 'under' a scrollsaw table very easily...
Gives me some Ideas as I work on my new stand!
~~~GB~~~
-
I think I have some for you later this week.
-
GB, I have that on my drill press connected to my dust collector. It works OK, but not great. Attached to a scroll saw, It may work pretty good.
-
I am building a new stand and this looks like a workable solution to put under the table of my 788.
I can fashion out of parts from HD or Lowes. Like mount the 'rectangular' nozzle to the stand just under the front of the saw to catch all that fine stuff that usually ends up on my lap and knees.
Will put the vacuum plug on the same 'foot switch' as the saw so it doesn't run constantly and drive me nuttier!
~~~GB~~~
-
GB I also have one of these hooked to my drill press (sanding station) and it works pretty good. I had the same thing hooked up to the top of my Hegner and it started getting in the way so I removed it. I think I will hook it up the bottom of the saw to see how that works.
Hawaiilad
-
I'll be interested in how it works under the Hegner (and how you attached it).
Cathy
-
I use an old canister vacuum cleaner on my saw,hooked to the saws bottom port it works OK.
It has a switch on the top, turn it on & off with my foot every time I turn the saw on & off.
JP