Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: pingjockey on July 03, 2011, 09:51:55 am

Title: Sconce pattern
Post by: pingjockey on July 03, 2011, 09:51:55 am

Does anyone have any southwest themed sconce patterns?
desert93601@embarqmail.com

Thanks,
Mark

Title: Re: Sconce pattern
Post by: tux_linux on July 03, 2011, 11:47:49 am

Mark,
What should this be? A pattern for a wall light?

Please take a minute to introduce yourself here (http://stevedgood.com/community/index.php?board=1.0).

Title: Re: Sconce pattern
Post by: Oges on July 04, 2011, 04:46:45 am

Hi Mark,
Here is a Southwest themed sconce to start you off, hope it's to your liking.

I would probably do the main sconce part in 3/4" material, the size is designed to be 10" in height.

The sconce ledge that will hold the tealight candle can be done in 1/2" materia and is designed to be size of 4.5" x 4.5" to hold a 1.5" candle adequately. The ledge should be set along the edge under Kokopelli's feet.

I would use Rapid Resizer to acurately print the patterns to their intended sizes.

Title: Re: Sconce pattern
Post by: Chachi on July 04, 2011, 08:46:17 am

Wow Good Job Oges I snaged My copy Thanks...

Title: Re: Sconce pattern
Post by: Oges on July 04, 2011, 04:57:53 pm

Okay after printing it out, I think the sconce printed at 7x5 and ledge at 3x3 would be a better size. But I guess people can print it to the size they prefer.