Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: crusty59 on April 29, 2010, 10:19:16 am

Title: Dimensional Snow Flake
Post by: crusty59 on April 29, 2010, 10:19:16 am

This was a trial piece for me. I learned to stack cut with this plan. I am storing these up for the winter season. I made them from 1/8 baltic birch. Then painted some of them white

[attachment deleted by admin]

Title: Re: Dimensional Snow Flake
Post by: Marshall on April 29, 2010, 12:36:53 pm

I think I have this pattern , I may have to try this one later .  I think you have done an outstanding job here ........

Title: Re: Dimensional Snow Flake
Post by: garyinnevada on April 29, 2010, 07:26:33 pm

Fine Job Sir!

Welcome to Stack Cutting!!

Title: Re: Dimensional Snow Flake
Post by: Joesawdust on April 29, 2010, 09:15:31 pm

Fantastic work, glad ya showed us.
Greg

Title: Re: Dimensional Snow Flake
Post by: cherie on April 30, 2010, 07:31:16 pm

I also have the pattern.. One question, is it difficult to put together?

Title: Re: Dimensional Snow Flake
Post by: crusty59 on May 02, 2010, 01:04:29 pm

Hi Cherie. It can be as little tricky, but it's not really hard. I would definitely stack cut though. Let me know when you are ready to cut and I will try to give you any tips

Title: Re: Dimensional Snow Flake
Post by: cherie on May 03, 2010, 07:37:25 am

Thanks Crusty, I have yet to go find it in my filing cabinet.