Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: emtdonald on May 17, 2011, 01:19:16 am

Title: Need Help with Royal Ambassador Pattern
Post by: emtdonald on May 17, 2011, 01:19:16 am

I am trying to make a royal ambassadors shield to put on a door at church. I need help turning the picture in to a pattern. It is not going to be sold it is for private use only.

Title: Re: Need Help with Royal Ambassador Pattern
Post by: TripleB on May 17, 2011, 03:04:55 am

Here ya go Donald, hope this works for you. Cut the black, and if you would like, on the crown and the branch, either cut as is with the bridges or just cut the peices without the bridges and glue them to the backer.

Bob

Title: Re: Need Help with Royal Ambassador Pattern
Post by: Waddawood on May 17, 2011, 03:10:05 am

Nothing is attached to your reply Triple.

Title: Re: Need Help with Royal Ambassador Pattern
Post by: TripleB on May 17, 2011, 03:45:27 am

Charlie, can you say "Brain Fart"? LOL...guess it's a lil late tonight. All fixed now.

Title: Re: Need Help with Royal Ambassador Pattern
Post by: emtdonald on May 17, 2011, 06:34:30 am

Thanks that is pretty good. I had also thought about cutting some of the inside parts at a 2 degree angle so the would raise up some but not sure how it would look. Thanks I will try that and see how it looks.

Title: Re: Need Help with Royal Ambassador Pattern
Post by: Waddawood on May 17, 2011, 07:56:19 am

I can relate Triple.  There is a constant stench around here due to them.  Good work ;)