Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: scrollriffic on April 27, 2010, 12:38:12 pm

Title: Relief Cross
Post by: scrollriffic on April 27, 2010, 12:38:12 pm

Here is Steve's relief cross I cut out today.It is maple with a cedar base. I drilled a 1/4" hole in the base and the bottom of the cross instead gluing them together. Thanks Steve for the pattern .Bobby

[attachment deleted by admin]

Title: Re: Relief Cross
Post by: northie66 on April 27, 2010, 07:57:58 pm

That looks really cool.  I'm not understanding how you attached them to the base though.  Did you put a screw threw the bottom for each section?

Title: Re: Relief Cross
Post by: scrollriffic on April 28, 2010, 01:25:02 pm

No I just drilled a hole in the middle piece and a hole three fourths of the way in the base and put a dowel in to hold it.Hope this clears it up. Let me know. Bobby

Title: Re: Relief Cross
Post by: Barry on April 28, 2010, 08:31:27 pm

Nice work Bobby.

Barry