Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: spiderman on May 05, 2011, 07:38:02 pm
-
Before you replaace the thmbscrews that hold the blade in the clamps on your dewalt 788 spray a little penetrating oil such as wd40 onto the spinning pieces at the end if those pieces don't spin it can be difficult to tighten a blades properly often a little penetrating oil will loosen up the stuck pieces wipe off the execess oil before trying to clamp a blade the oil can cause your blades to slip