Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: mrsn on April 10, 2011, 07:33:31 pm
-
I used Sue Mey's new letter set to make these welcome signs.
One is 1/2" mahogany and the other is 1/8" baltic birch plywood.
To make the backer for the plywood one I used a flat washer against the word and traced around. The washer keeps the pencil an even 1/2" away.
MrsN
-
Those are really nice. You did a great job on both pieces... As usual!
Louis
-
very nice Katie like the idea you did for the backer board.thanks for sharing
-
Great Job nice cut and thanks for the backer tip.
-
Very nice Katie!
-
The both look very nice Katie, thanks for sharing.
Bruce ;D
-
I like both of them Katie. Thanks for sharing them with us and the tip on the backer.
DW
-
Awesome job MrsN, those turned out great.
Thanks for sharing.
-
great work there, looks wonderful.
-
Awesome job, I like it. Thanks for posting. :)
-
Great job, Katie.
-
Amazing and wonderful.
Very nice work
-
Great work, and thanks for the great tip!
Bill
-
That looks good Katie. I remember making these with crayons and paper. That was a long time ago. Thanks for sharing with us. Bobby