Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: frankorona on March 20, 2011, 06:29:33 pm

Title: matches by Steve
Post by: frankorona on March 20, 2011, 06:29:33 pm

With a slight modification, I hope not bother Steve about the changes I make in some of their patterns

Title: Re: matches by Steve
Post by: DWSudekum on March 20, 2011, 06:48:09 pm

Great job Frank.  Patterns are just guides.  We do change patterns every time we cut a pattern not a problem.  Thanks for sharing it with us.


DW

Title: Re: matches by Steve
Post by: Gabby on March 20, 2011, 06:59:14 pm

I like it Franko, it looks very neat and trim. Is it designed to hang on the wall?
I see you filled it with safety matches, and put a strike pad on the front, can it be taken off for replacement when it wears out?
Good work,
Gabby

Title: Re: matches by Steve
Post by: newfie on March 20, 2011, 08:22:25 pm

you did a good job with it thanks for sharing

Title: Re: matches by Steve
Post by: Russ C on March 20, 2011, 08:32:26 pm

Looks great, nice work. I think Steve will like it.  :)

Title: Re: matches by Steve
Post by: GrayBeard on March 20, 2011, 10:41:35 pm

Well done, amigo!

Looks like the striker is on with 'foam tape'.

~~~GB~~~

Title: Re: matches by Steve
Post by: tux_linux on March 21, 2011, 11:31:34 am

Yes, might even look better than the original plan. I like your idea.

regards
Torsten

Title: Re: matches by Steve
Post by: Tim2beupinAz on March 21, 2011, 01:57:56 pm

I like it. Great looking item there.

Title: Re: matches by Steve
Post by: Dawie on March 23, 2011, 08:20:12 am

Looks great Frank.
David

Title: Re: matches by Steve
Post by: Mainewoods on March 23, 2011, 08:25:18 am

Another good job!