Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: crusty59 on April 24, 2010, 01:21:32 pm
-
This was my first try atcreating a wooden gear clock. I have about 200 hours into it. I finally got it to run. It runs a little fast, I have to put a longer pendulum on it to slow it down. I made all the parts from baltic birch plywood. It's hanging in my living room. I'll have to take a better picture of it. I plan on doing another one soon
[attachment deleted by admin]
-
Very nice Crusty. Especially like your wgt.
Chips
-
Wow... you must have a lot of patience.
-
Way cool clock Crusty! Thanks so much for sharing it with us.
Christina
-
That looks nice. I am working on my first clock now. Hopefully it wont take to long.
-
I promised my self that I would give one of these clocks a go Yours look fantastic thanks for sharing
-
real - real - fine - work .........
-
Nice job. What pattern is that? I been wanting to do another clock for a while, I built the Thomas wall clock and it's keeping good time for about two years now. As to timing the clocks it is a challenge but with some tinkering I got mine to about a minute or two a day.
-
I got this pattern from my dad. He purchased it from Rick Hutcheson. http://www.scrollsaws.com/
-
Very nice. Looks difficult though
-
I've always wanted to build one...your looks AMAZING!! Nice job...
-
very cool indeed. thanks
-
magn?fico trabajo, se requiere paciencia y presici?n felicidades