Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: frankorona on January 28, 2011, 09:00:42 am

Title: i need help
Post by: frankorona on January 28, 2011, 09:00:42 am

Hello everyone:
  I have a small problem.
I'm trying to cut the cube pattern puzzle by Steve.
The problem is that when the cutting blade is deformed by the force that carried out to cut wood, the final piece is cut, but inside is burned or cut is deformed.
the question is: what should I do, how fast I have to work the jig?
I am working with a cutting blade No. 7 in Pine.
Thanks in advance for your help and greetings from Puebla, Mexico

Hola a todos:
 Tengo un peque?o problema.
Estoy tratando de cortar patr?n  del cubo puzzle realizado por Steve.
El problema es que a la hora del corte la hoja de sierra se deforma por la fuerza que realizo para que corte la madera, al final la pieza queda cortada, pero en su interior est? quemada o bien est? deforme el corte.
la pregunta es:?qu? debo hacer, a qu? velocidad debo de trabajar la caladora?
estoy trabajando con una hoja de corte N?7 en Madera de pino.
De antemano gracias por su ayuda y saludos desde Puebla, M?xico

Title: Re: i need help
Post by: julief on January 28, 2011, 09:36:25 am

Either you blade is not tight enough or you are pushing the wood too hard.

Title: Re: i need help
Post by: pauley555 on January 28, 2011, 01:28:16 pm

hi,i would agree with julief on this,regards paul

Title: Re: i need help
Post by: Gary on January 28, 2011, 02:13:49 pm

I would add to these suggestions that you be sure you use tape around the block for lubrication....Gary

Title: Re: i need help
Post by: Russ C on January 28, 2011, 02:50:10 pm

I agree with the others. Also makes sure your saw speed is set on high/fast.  :)

Title: Re: i need help
Post by: boxmaker on January 28, 2011, 09:33:41 pm

I think you are probably pushing to hard on the blade. Cutting thick wood is a lot different. If you know your tension is right, then watch the blade when cutting, if it deflects you are pushing to hard. This will also make it burn, because the blade cannot eject the chips fast enough and the blade will generate heat and burn your wood.