Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: david45 on January 28, 2011, 07:48:00 am

Title: promble
Post by: david45 on January 28, 2011, 07:48:00 am

i am using a.2 blade an it wont stay in my srcollsaw its delta any help

Title: Re: promble
Post by: julief on January 28, 2011, 08:01:50 am

What might be the problem is, if you are used to using a bigger blade, you could have a wear pattern in you blade holders.  It may be just enough to keep from getting a grip on the tinier blade.  You might rough up the ends of your blade holders just a bit.

Title: Re: promble
Post by: Russ C on January 28, 2011, 08:30:08 am

Try cleaning the ends of the blade too. They can have a small amount of oil from manufacturing. You can also lightly sand the ends of the blade.  8)

Title: Re: promble
Post by: tux_linux on January 28, 2011, 09:32:58 am

The problem seems to be confusing - he even lost his grammar  :o

Clean the clamps too. There might be too much dust in there - especially if it's the bottom clamp.

regards
Torsten

Title: Re: promble
Post by: pauley555 on January 28, 2011, 01:27:03 pm

not sure but on my scroll saw i have different size blade holders for different  blades,and had same problem until i got the right sized holder,hope this may be of help,regards paul