Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: ups34 on December 19, 2010, 06:40:06 am

Title: Delta SS350
Post by: ups34 on December 19, 2010, 06:40:06 am

Anyone using a Delta SS350 ? Looking for some information on that saw. I need the height of the saw from the bottom to the table. I have one in Fl. and building a stand for it here in Maryland to take there.

Title: Re: Delta SS350
Post by: KYCustomScroller on December 19, 2010, 08:22:53 am

i use it i just bought a new one on stand and ever stuff.....................?????

Title: Re: Delta SS350
Post by: ups34 on December 19, 2010, 01:30:41 pm

Ky.
Can you help me with the measurement. I don't have it here.

Title: Re: Delta SS350
Post by: ups34 on December 19, 2010, 01:36:13 pm

KyCustom
If you are using a SS350 you must have bought it used.

Title: Re: Delta SS350
Post by: KYCustomScroller on December 19, 2010, 06:38:21 pm

yea brb i'll go get the measurements, Ok from my concrete shop floor to the bottom of the base of the saw is 30 3/8" i hope this helps you.

Title: Re: Delta SS350
Post by: KYCustomScroller on December 19, 2010, 06:42:29 pm

Quote from: ups34 on December 19, 2010, 01:36:13 pm

KyCustom
If you are using a SS350 you must have bought it used.

yea it was used very little it was in new condition not a scratch on it

Title: Re: Delta SS350
Post by: ups34 on December 19, 2010, 08:23:47 pm

KYCustom
Thanks but I was looking for how tall the saw is from the bottom of the saw to the table. It should be something like 8 inch.
Thanks for your help