Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: towdude3 on November 16, 2010, 01:10:14 am

Title: Pie Stand
Post by: towdude3 on November 16, 2010, 01:10:14 am

This is a pie or cake stand. I got the pattern off the internet. Enlarged pattern to 175 percent to use 1/4 inch wood. Not quite finished yet. Still need to sand a little more and put a finish on it. It was fairly easy to cut.

Title: Re: Pie Stand
Post by: Russ C on November 16, 2010, 06:30:10 am

Good job, Nice work. Thanks for sharing.  8)

Title: Re: Pie Stand
Post by: heiko rettberg on November 16, 2010, 07:14:31 am

looks greate, good job.

Title: Re: Pie Stand
Post by: Dawie on November 16, 2010, 07:49:37 am

Very nice.
David

Title: Re: Pie Stand
Post by: dgman on November 16, 2010, 09:31:50 am

Dude! Looks good. What wood did you use? Show us a pic when it is finished.

Title: Re: Pie Stand
Post by: Judy Hunter on November 16, 2010, 10:56:28 am

I would love to cut that.  You did a great job! Would you share the pattern or tell me where you found it? please

Title: Re: Pie Stand
Post by: towdude3 on November 16, 2010, 11:19:56 pm

I used something called 5 mm cat. Not really sure what it is but i got it at Home Depot. It is about 1/2' thick. Only problem i have had with it so far is you have to be really careful sanding it and any delicate fretwork will chip.

Title: Re: Pie Stand
Post by: towdude3 on November 17, 2010, 12:21:28 am

Judy,
I emailed you the source of the pattern. It is not mine and i'm not sure if I can post it here even though it's free. Don't want to cause any problems for anyone. Mike
 

Title: Re: Pie Stand
Post by: MadHatter on November 17, 2010, 08:00:42 am

wow beautiful job. id love to have the pattern if possible.