Scrollsaw Workshop Community -Please register to enable posting.

General Category => The Coffee Shop => Topic started by: WigWag Workshop on October 28, 2010, 05:33:09 pm

Title: Sig part 2
Post by: WigWag Workshop on October 28, 2010, 05:33:09 pm

Good Day Folks!

Every time I try to add an avatar, my train in the sig, gets shrunk down. I remove the avatar, but the train is still small.  Any ideas  ;D  Hope all is well, and thanks in advance for any help.

Steven 

Title: Re: Sig part 2
Post by: grampa on October 28, 2010, 05:40:31 pm

Hi Steven, Its gone narrow gauge ;D,  try deleating the train then reinstall it, might work.......Paul

Title: Re: Sig part 2
Post by: WigWag Workshop on October 28, 2010, 05:50:44 pm

Quote from: grampa on October 28, 2010, 05:40:31 pm

Hi Steven, Its gone narrow gauge ;D,  try deleating the train then reinstall it, might work.......Paul

That's funny  ;D I went from HO scale to Z scale - I tried to delete and add again, same thing

Title: Re: Sig part 2
Post by: Marcellarius on October 29, 2010, 06:43:11 am

I noticed that the forum software resizes the avatar picture automatically .
perhaps it does the same simultaneously to the sig pic.

you could try to:
remove the sig pic
save the config
close your web browser
clear your browser memory (maybe reboot your system)
start the forum and add the sig pic again?

Title: Re: Sig part 2
Post by: WigWag Workshop on October 29, 2010, 04:27:26 pm

Quote from: Marcellarius on October 29, 2010, 06:43:11 am

I noticed that the forum software resizes the avatar picture automatically .
perhaps it does the same simultaneously to the sig pic.

you could try to:
remove the sig pic
save the config
close your web browser
clear your browser memory (maybe reboot your system)
start the forum and add the sig pic again?

Did all that same issue - It did start when I added a avatar.

Title: Re: Sig part 2
Post by: Rightarm on October 29, 2010, 08:22:59 pm

    I don't know. But I think you went from a train to a worm. Dave 8)

Title: Re: Sig part 2
Post by: WigWag Workshop on October 29, 2010, 10:25:49 pm

Well, I guess it's either the full size train, and no avatar or z scale train w/ avatar.
Thanks all for the suggestions

Steven

Title: Re: Sig part 2
Post by: Dawie on October 29, 2010, 10:52:52 pm

I used to have a z scale so I am partial to small trains.
David

Title: Re: Sig part 2
Post by: GrayBeard on October 29, 2010, 10:53:19 pm

It may be that there is only so much 'space' in the profile for the 'avatar' and the 'signature'.

~~~GB~~~