Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Kepy on October 26, 2010, 12:27:41 pm

Title: Ornaments
Post by: Kepy on October 26, 2010, 12:27:41 pm

These are part of the ornaments from Steve's pattern.  They are cut from cedar fence board that I found in the cull box at Home Depot and then planed down.  Managed 16 ornaments for a material cost of 51 cents.

Title: Re: Ornaments
Post by: hackergranny on October 26, 2010, 12:29:39 pm

Verry nice and made at such a great price too.

Title: Re: Ornaments
Post by: Dawie on October 26, 2010, 12:38:25 pm

They look great and at that price you can never loose.
David

Title: Re: Ornaments
Post by: GrayBeard on October 26, 2010, 12:43:14 pm

They look great!
I love those 'culls'!

Made lots of bird feeders from those same boards!

~~~GB~~~

Title: Re: Ornaments
Post by: Russ C on October 26, 2010, 01:06:32 pm

Nice work, I like them. Thanks for posting  8)

Title: Re: Ornaments
Post by: julief on October 26, 2010, 01:25:04 pm

Looks Great!

Title: Re: Ornaments
Post by: MadHatter on October 26, 2010, 02:29:54 pm

good job, thanks for sharing with us.

Title: Re: Ornaments
Post by: Joesawdust on October 26, 2010, 09:52:54 pm

Those look great

Title: Re: Ornaments
Post by: newfie on October 27, 2010, 08:01:31 am

nice job kepy

Title: Re: Ornaments
Post by: SamCec on October 27, 2010, 08:21:59 am

Very nice work. I wish I could do circular cuts like that--so smooth!!!!!
practice, practice and more practice.

Sam

Title: Re: Ornaments
Post by: boxmaker on October 27, 2010, 05:18:08 pm

They look great Kepy, Gotta love those bargain bins.

                                                            Mark

Title: Re: Ornaments
Post by: dgman on October 27, 2010, 06:44:01 pm

Good job Kepy!