Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: boxmaker on October 21, 2010, 08:24:53 pm
-
I normally use FD-UR#3 and #5 and #7, lately I have been cutting more detailed cuttings and I want to order some new blades. I like the FD-UR#3, but was going to order some smaller blades, what I was wondering is the difference between the FD-UR#1 and the FD-SR 2/0, I see they both use the same drill size, will one cut tighter turns than the other. I am not that familiar with the smaller blade sizes. What would you recommend for cutting portrait style patterns. I generally stack cut 2 or 3 1/4" pieces. Spirals are not an option, I tried them when I first started and never liked them.
Mark
-
Hey Mark, You can try a FD UR#1, but that still might be to big. I did get some FD SR 2/0, but I can't control them. So when I need small blades I use Olsen 2/0R.
I'm not a fan of spirals, but when a flat blade won't cut it, I use FD NS spiral blades, usual in 2/0 size.
-
Mark, Yes you will get tighter turns but they are a little hard to control. Slow your machine way down and take your time. If your stack cutting, make sure your table is square and the blade is feeding evenly. It's real easy for a blade that small to get off track on the lower levels of your stack and you wont know it until its too late.
-
Small blades are harder to control when stack cutting. The FD-SR 2/0 is sweet for thin material and fret work. If you need detailed cuts with a smaller blade, I recommend limiting the stack to two 1/4", FD-UR No. 1 and a little slower speed. That has worked for me. 8)
-
I want to thank everyone for the information. I did slow my speed down when I started cutting the fretwork, using the FD-UR#3 and it helped, but I figured a smaller blade would give me better turns. I think I will order some FD-SR 2/0 and a few of the FD UR 1 and some Olson 2/0 R today. I figured I 'll just pick a project and switch out different blades until it feels right. Thanks again, I know this was a difficult question to answer, but I now have a better understanding of what small blades can do.Thanks again.
Mark