Scrollsaw Workshop Community -Please register to enable posting.

General Category => Intarsia => Topic started by: cathodge on October 12, 2010, 07:29:52 pm

Title: viens on the intarsia
Post by: cathodge on October 12, 2010, 07:29:52 pm

How do you form the lines on an intarsia project. Such as a leaf. How so you form the views?

Title: Re: viens on the intarsia
Post by: daneklund on October 13, 2010, 09:28:28 am

I use a wonder wheel to make accent lines.  I have also used a dremel with a carving burr.  The wonder wheel is available from JGR at www.intarsia.com.

Title: Re: viens on the intarsia
Post by: wdkits1 on October 13, 2010, 11:25:54 am

I use a dremel tool with assorted cutters to carve accent lines. The easiest way is to carve the lines before you remove the paper pattern.

(http://i712.photobucket.com/albums/ww126/wdkits1/intarsiatutorialshapingandcarvin-2.jpg)