Scrollsaw Workshop Community -Please register to enable posting.

General Category => The Coffee Shop => Topic started by: sp_343 on September 01, 2010, 10:58:15 am

Title: Relief/Inlay Practice
Post by: sp_343 on September 01, 2010, 10:58:15 am

Steve had a pattern on his blog with 6 or 8 half circles on a block of wood.  Then you cut each circle out starting with 1 degree, then the next at 2 degree, the next at 3 degree, etc...  It was used to practice relief cutting or to test the fallout when cutting on a tilted table.

I searched on the blog but can't find that pdf. pattern...anyone know where it is or what it is called so I can get a copy?

Thanks!

Title: Re: Relief/Inlay Practice
Post by: Dawie on September 01, 2010, 12:25:13 pm

Hi sp I think this is what you are looking for, it just so happens that I was looking for it too earlier on this week so here's the link http://www.stevedgood.com/bevelgauge.pdf
David

Title: Re: Relief/Inlay Practice
Post by: ChaplainRon on September 01, 2010, 12:25:39 pm

Here is Steve's Catalog.

http://www.stevedgood.com/web/catalog.html

Title: Re: Relief/Inlay Practice
Post by: sp_343 on September 01, 2010, 02:14:41 pm

You the man David!  That's it...thanks bud!!

Title: Re: Relief/Inlay Practice
Post by: Russ C on September 01, 2010, 02:30:34 pm

I see David beat me to it. LOL Good job.  8)