Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: GrampaJim on May 25, 2015, 09:37:25 am

Title: Eagle pattern by Steve
Post by: GrampaJim on May 25, 2015, 09:37:25 am
This is probably my favorite pattern.  I cut it from 1/2" oak and put it on a 1" thick stand.  Used #1 and 3# FD blades for most of it and tried 0/2 spiral FD blade for the really small cuts. 
Jim
Title: Re: Eagle pattern by Steve
Post by: DWSudekum on May 25, 2015, 09:40:10 am
Very nicely done Jim.  That came out great.  Thanks for sharing this with us.


DW
Title: Re: Eagle pattern by Steve
Post by: Kepy on May 26, 2015, 08:09:37 am
Very nicely done.  I'm glad to see someone using oak as it often gets a bad rap. 
Title: Re: Eagle pattern by Steve
Post by: GrampaJim on May 26, 2015, 09:19:02 am
Thanks Kepy.  I like oak because it looks nice when finished.  A little harder to cut, but worth it. 
Title: Re: Eagle pattern by Steve
Post by: frankorona on May 26, 2015, 10:12:50 am
Wonderful work, looks very well done, thanks for sharing.
Title: Re: Eagle pattern by Steve
Post by: pierre62 on May 26, 2015, 01:00:31 pm
Very nice done, thanks for sharing.
Title: Re: Eagle pattern by Steve
Post by: heiko rettberg on May 27, 2015, 01:19:44 am
Very nice done.
Title: Re: Eagle pattern by Steve
Post by: wombatie on May 27, 2015, 02:26:41 am
A truly beautiful piece of work Jim

Marg
Title: Re: Eagle pattern by Steve
Post by: Rover2 on May 27, 2015, 08:52:03 pm
Nice work Jim and thanks for sharing with us.

Al
Title: Re: Eagle pattern by Steve
Post by: gordster on May 28, 2015, 06:11:05 am
Excellent job Jim..its a beauty