Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: sp_343 on July 15, 2010, 11:29:58 am

Title: Bulldog
Post by: sp_343 on July 15, 2010, 11:29:58 am

A Pine plaque with a relief cut middle.  University of Minnesota @ Duluth "Bulldog's" logo cut into it.  Not my alma mater...for a family friend.

[attachment deleted by admin]

Title: Re: Bulldog
Post by: MadHatter on July 15, 2010, 11:41:24 am

looks great !!

Title: Re: Bulldog
Post by: Dawie on July 15, 2010, 12:11:52 pm

Super piece of work.
David

Title: Re: Bulldog
Post by: rwb on July 15, 2010, 12:43:46 pm

luv the bulldog

Title: Re: Bulldog
Post by: Russ C on July 15, 2010, 12:46:49 pm

Nice job, I like it. Thanks for posting your work.  8)

Title: Re: Bulldog
Post by: Marcellarius on July 15, 2010, 05:04:41 pm

very nice. sure you brag this one!

Title: Re: Bulldog
Post by: northie66 on July 15, 2010, 05:44:19 pm

Very nice... did you do this one on an angle also?

Title: Re: Bulldog
Post by: sp_343 on July 15, 2010, 08:33:30 pm

Janet:  I drilled the entry hole and set the scroll table at 2 degrees.  Then relief cut out the middle, took it out...worked on the outside part (sanding, routing, staining, etc...) and cut the design into the middle.  Put the two pieces together with some glue and finished it with some spray poly.

I like the way the relief cut plaques turn out.  Gives it the 3-D look and easy to do.

Title: Re: Bulldog
Post by: Becky on July 15, 2010, 11:14:21 pm

Looks great!

Title: Re: Bulldog
Post by: Judy Hunter on July 15, 2010, 11:23:17 pm

That looks really great!  So then the light colored bulldog part is actually set back from the darker frame??
hard to tell in the picture.

Title: Re: Bulldog
Post by: sp_343 on July 16, 2010, 06:38:35 am

The pic is bad for this...the light part is actually pushed out to the front and is about 1/4" higher than the back part.  This is a pic of the Barney Fife plaque I cut...same method used.

[attachment deleted by admin]

Title: Re: Bulldog
Post by: Judy Hunter on July 16, 2010, 10:00:00 am

ok I got it now...thanks.  That is really cool.  gonna have to try that one of these days.