Scrollsaw Workshop Community -Please register to enable posting.

General Category => Introduce Yourself. => Topic started by: Ron/IA on November 13, 2014, 11:45:30 pm

Title: New Scroller
Post by: Ron/IA on November 13, 2014, 11:45:30 pm

I inherited an unused KingCraft MQ50 16" scroll saw a couple of years ago, and took it out of the box yesterday.

I have used a scroll saw a total of once, and it was so long ago I don't even remember what I cut.

I am wondering if anyone has tried to use this saw with pin-less blades.

Thanks, Ron

Title: Re: New Scroller
Post by: wombatie on November 14, 2014, 12:40:45 am

Hi Ron, welcome to the site.  I'm Marg from Australia.  Sorry can't help you with the saw question.

Marg

Title: Re: New Scroller
Post by: Russ C on November 14, 2014, 05:47:55 am

Glad you found us Michael. Hi I'm Russ from Florida your local moderator. Welcome to the Scrollsaw Forum.  :)

Sorry can't help you but your question might be better answered in a General Scrollsaw Talk where most questions like this are posted, rather than the category for Introducing Yourself to the forum.

Title: Re: New Scroller
Post by: pierre62 on November 14, 2014, 06:45:43 am

Welcome to the forum.
I am Pierre from Qu?bec, Canada

Title: Re: New Scroller
Post by: julief on November 14, 2014, 06:52:04 am

Hi Ron and welcome to the forum.  I'm Julie from Texas.  Glad to have you.

Title: Re: New Scroller
Post by: Ron/IA on November 14, 2014, 08:50:00 am

Everyone - Thanks for the replies, I appreciate it.

Also, thanks for the suggestion of putting my question in the general scroll saw category.

By the way, this forum was suggested by a sscroller who lives not too far from me (about 20-miles).