Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: Dakota Saw Dust on June 14, 2014, 11:18:54 pm
-
Started one of Sheila Landry 's Self framing projects. Of course it requires a blank entry hole [angled] to cut out the center part. I found that I don't like the size of my entry hole. It is small but I would like to fill it. I've saved some of the maple saw dust for mixing with glue. Now here's the question. What glues have been tried that don't show up? I will not be staining this, only applying a clear sealer. Thanks for any input in advance Brian
-
I use Gorilla Glue for wood. (The WHITE one, not the AMBER colored one!) It dries clear and is super strong.
Let me know how you do. :)
Sheila
-
If you decide to try a wood filler, I have had great success with the Timbermate brand. It comes precolored in a variety but also stains well and sands well. Better than any I've tried.
-
I use Elmer's white glue mixed with sanding powder from, my orbital sander. Not sawdust. Saw dust is not fine enough to work well. It may take more than one coat of this mixture because it shrinks a bit as it dries.
-
Welbond works good too, dries clear, and is strong. wood filler works good also. edward
-
Aileen's tacky clear glue works great as well and dries clear. I also use the sanding "powder" from my RO sander or from under my scroll saw. I keep ziplock bags of different species so it is pure.
-
Another little tip you may use. I put a piece of tape over the hole I want to repair, make sure it is really tight against the wood, then poke the hole thru the tape with a small awl or even a toothpick. Then you apply the mix of glue and sawdust in the hole, let it dry real good. Remove the tape, touch it with a little sanding and VOLA. After a while you won't be able to find the hole. Good Luck
:) :) :)
-
Thanks for all the repair pointers. I finally found Gorilla white glue - also clear. And I'm glad you pointed out orbital sander powder Jim. As for the tape over the hole ChuckD - my hole to be repaired is half on my plate rim and half on the plate center cut out. I want to repair the voids before I assemble the unit. BUT I'm glad you brought up your technique. I'm putting that one in the back of mind. Sure hope is doesn't get lost. Thanks again everybody. Brian
-
You could also do this without glue, simply take an iron, lay a damp towel over the hole with the iron on top. If the hole is small the steam should close it up.