Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: crusty59 on July 05, 2010, 11:57:25 am

Title: Baseball Mitt
Post by: crusty59 on July 05, 2010, 11:57:25 am

I made this piece for a  friend. Cut it out of 3/4 Red Oak

[attachment deleted by admin]

Title: Re: Baseball Mitt
Post by: Rapid Roger on July 05, 2010, 12:00:56 pm

I like that one! Very cleaver!! and a good job scrolling too!

Rog

Title: Re: Baseball Mitt
Post by: ufgator on July 05, 2010, 12:39:15 pm

Looks Great! Nice work.

Happy Scrolling
     Bill

Title: Re: Baseball Mitt
Post by: MadHatter on July 05, 2010, 06:30:47 pm

very nice.

Title: Re: Baseball Mitt
Post by: sp_343 on July 05, 2010, 07:14:04 pm

I like the glove and that stand is really a nice touch.  Great job on the cut!

Title: Re: Baseball Mitt
Post by: Dan on July 05, 2010, 08:03:23 pm

Great pattern and work. Is it available? And where?

Dan

Title: Re: Baseball Mitt
Post by: Dawie on July 06, 2010, 05:57:05 pm

Lucky friend. Looks great. Thanks for sharing.
David

Title: Re: Baseball Mitt
Post by: jimbo on July 06, 2010, 06:40:49 pm

i bet your freind was pleased with that, nice work
Jimbo