Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: Dawie on June 30, 2010, 04:58:05 pm
-
Oeps forgeot to post the picture. Thanks Steve your video on photoplus6 helped me on my way nicely. Suggestions/comments welcome.
David
[attachment deleted by admin]
-
That is very nice!
I think I may have to try one...with your permission of course.
~~~GrayBeard~~~
-
Be my guest Gray just post us a pictures. Is it big enough to download, could PM you the original one if you like.
David
-
I just picked up a nice 'oval' from Michael's and I am going to try and fit it on there. Not too big but I have a grand daughter that is very 'in' to giraffes!
I'll have to try it next week...this one is full up with 'stuff' to do!
I am also going to use this to 'experiment with my first ever 'spiral blades'!
Thanks
~~~GrayBeard~~~
-
Hope your granddaughter likes it. I used spiral blades for the first time a while back. Actually enjoyed using them, gives you a lot more freedom as you are not limited to the depth of your saw.
Will proverbly start using them more in combination found them especially handy for tight cornors.
I'll be off to bed now it's 0.04 am here so good morning on the 1st of july.
David
-
Darn nice job for the 1st design. Can't wait to see it cut...thanks for posting!
-
Pattern looks good.
-
Dawie, the pattern looks great for a start. Keep up the practice and you can only get better.