Scrollsaw Workshop Community -Please register to enable posting.
General Category => The Coffee Shop => Topic started by: countryscroller on September 24, 2013, 09:21:24 pm
-
The progress I have made on the order I have. By the next video, I should have it finished. http://www.youtube.com/watch?v=f634Emn6Qjc&feature=c4-overview&list=UULAxz24dFceU8bIyUf_SQDw (http://www.youtube.com/watch?v=f634Emn6Qjc&feature=c4-overview&list=UULAxz24dFceU8bIyUf_SQDw)
-
Looks like some nice inlay work. I'm anxious to see how the finger joints com out.
-
Thanks, I got it glued up and everything went together good. Next I will sand it all then glue on the bottom,then attach the top
-
what do you do to keep it square while the glue dries?
-
Well after I clamped it up with the clamps both the length and width of it, I checked squareness and measured the length and width on both sides of it to make sure they are the same. Also with them being the finger joints they are, like the dovetail, they pretty much square themselves if you cut them right. If I had band clamps, I could put one on it like a picture frame and make sure it stays square through out the drying process. It should be good. I am typing this from school, so I am not in the shop right now. By the time I get home, I will be taking off the clamps and go from there.