Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Martin on July 22, 2013, 03:52:31 pm

Title: Chinese Dragon
Post by: Martin on July 22, 2013, 03:52:31 pm

Pattern made from a free vector clipart I found. I had the usual trials and tribulations that you get with rubbish ply with bits dropping off.

Title: Re: Chinese Dragon
Post by: EIEIO on July 22, 2013, 04:25:57 pm

Very nice cutting. clean and accurate.

Title: Re: Chinese Dragon
Post by: Merlin on July 22, 2013, 05:22:45 pm

Nice pattern and cutting I snagged a copy thanks.

***Merlin***

Title: Re: Chinese Dragon
Post by: Al W on July 22, 2013, 06:37:04 pm

Huh?  You cut it backwards  :D.  Nice job - looks very well done.  Thanks for sharing with us.

Al

Title: Re: Chinese Dragon
Post by: jrpeteo on July 22, 2013, 07:09:39 pm

Nice job, like the pattern too. Thanks.
Pete

Title: Re: Chinese Dragon
Post by: DWSudekum on July 22, 2013, 09:47:15 pm

I like it.  Looks like a friend of mines tat.  Thanks for sharing the cutting and the pattern with us.


DW

Title: Re: Chinese Dragon
Post by: Martin on July 23, 2013, 05:02:32 am

Quote from: Al W on July 22, 2013, 06:37:04 pm

Huh?  You cut it backwards  :D.  Nice job - looks very well done.  Thanks for sharing with us.

Al

Actually, lots of bits dropped off the front, so I had no option but to turn it around. :) If you compare with the pattern, there's also two large pieces missing.

Martin.

Title: Re: Chinese Dragon
Post by: wombatie on July 23, 2013, 05:27:00 am

Very very nice.

Marg

Title: Re: Chinese Dragon
Post by: countryscroller on July 23, 2013, 05:47:36 am

I didn't even notice a mistake in the pieces missing. Great work on it!

Title: Re: Chinese Dragon
Post by: Russ C on July 23, 2013, 08:21:38 am

Good job, still nice work. Thanks for sharing.  :)

Title: Re: Chinese Dragon
Post by: newfie on July 23, 2013, 08:36:28 am

nice cutting

Title: Re: Chinese Dragon
Post by: frankorona on July 23, 2013, 09:03:33 am

Very nice job, looks great and thanks for the pattern. ;)

Title: Re: Chinese Dragon
Post by: Marshall on July 23, 2013, 08:27:07 pm

Nice pattern and work ...........MB ;) :)

Title: Re: Chinese Dragon
Post by: Marcellarius on July 24, 2013, 03:58:55 am

nice dragon, did cut it great!