Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: Al W on July 06, 2013, 03:57:57 pm

Title: Multi page print in Corel
Post by: Al W on July 06, 2013, 03:57:57 pm
Albeit this section is labelled for Steve Good, I am looking for some help from anyone who has the answer.

I have designed a sign for over a doorway which measures 35 inches wide.  I believe I have that part done correctly, however, I am NOT able to get the scroll design to print.  I always get only one page, and can not figure out how to get the whole string of letters to print.

Suggestions?

Al
Title: Re: Multi page print in Corel
Post by: jrpeteo on July 06, 2013, 04:38:56 pm
If you can save a copy of it as a PDF file you can print from that. When you click on print, the print dialog box comes up, select "Poster". You should get a few pages, each with a portion of the pattern.
Hope this helps....
Pete
Title: Re: Multi page print in Corel
Post by: Al W on July 06, 2013, 08:06:08 pm
Thanks!!  Saving as a PDF worked fine.  Now off to the scroll saw.

Thanks again.
Title: Re: Multi page print in Corel
Post by: Tomsunnu on July 09, 2013, 07:17:53 am
If you can save a copy of it as a PDF file you can print from that. When you click on print, the print dialog box comes up, select "Poster". You should get a few pages, each with a portion of the pattern.
Hope this helps....
Pete

Thanks,Pete  :) this is a very useful tip. I always use to wonder about this while having big wordart design in my mind.
Mahendra