Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: troy_curtis on June 10, 2013, 07:14:04 pm

Title: Candle Holder
Post by: troy_curtis on June 10, 2013, 07:14:04 pm

Made this one today. Trying out some new projects for my fall sale. I think I like this one and stack cutting makes it easy and fast to make. I just put some oil on this to give it a stained look. The oil shows some glue spots I need to sand a bit better. Once I re-sand it I will apply a final finish. I made this out of some 1/2 in soft maple.

Title: Re: Candle Holder
Post by: Russ C on June 10, 2013, 10:04:05 pm

 Looks great, nice work. Thanks for sharing.  :)

Title: Re: Candle Holder
Post by: newfie on June 10, 2013, 10:27:30 pm

nice work

Title: Re: Candle Holder
Post by: countryscroller on June 10, 2013, 10:49:07 pm

Very nice work!

Title: Re: Candle Holder
Post by: IBMer on June 11, 2013, 12:00:22 am

Looks good, is the pattern public?

Title: Re: Candle Holder
Post by: BigPete on June 11, 2013, 07:50:16 am

Looks great , nicely done ...Pete

Title: Re: Candle Holder
Post by: frankorona on June 11, 2013, 07:58:59 am

Wonderful and great job, very well done, thanks for sharing

Title: Re: Candle Holder
Post by: troy_curtis on June 11, 2013, 11:52:37 am

Quote from: IBMer on June 11, 2013, 12:00:22 am

Looks good, is the pattern public?

Yes this pattern is off this site. Thank you Steve Good for the pattern. =)

Title: Re: Candle Holder
Post by: wombatie on June 11, 2013, 09:43:23 pm

Very nice Troy, well cut.

Marg