Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: newfie on October 16, 2012, 06:42:31 pm

Title: Fisherman plaque
Post by: newfie on October 16, 2012, 06:42:31 pm

cut this one for our neighbors for Christmas.the backer is 1/4" birch plywood and the top is the 1/4" meranti board.just paint the top part with black spray paint and clear coated the whole thing.the pattern is by Steve Good.

Title: Re: Fisherman plaque
Post by: countryscroller on October 16, 2012, 07:11:05 pm

Looks Great Todd!

Title: Re: Fisherman plaque
Post by: DWSudekum on October 16, 2012, 08:12:56 pm

Very nicely done Todd.  I too am cutting that one... it is about 1/3 done.  Thanks for sharing yours with us.

DW

Title: Re: Fisherman plaque
Post by: newfie on October 16, 2012, 10:20:07 pm

thanks guys.those letters are hard to cut!

Title: Re: Fisherman plaque
Post by: Keefie on October 17, 2012, 04:01:18 am

looks great Todd

Title: Re: Fisherman plaque
Post by: Russ C on October 17, 2012, 07:18:02 am

Great job, nick work. Thanks for sharing.  :)

Title: Re: Fisherman plaque
Post by: Al W on October 17, 2012, 09:22:45 am

Nice job, thanks for sharing with us.

Title: Re: Fisherman plaque
Post by: frankorona on October 18, 2012, 08:58:48 am

Very nice job, looks great

Title: Re: Fisherman plaque
Post by: dgman on October 18, 2012, 10:11:13 am

Nice work Todd!

Title: Re: Fisherman plaque
Post by: slowcutter on October 18, 2012, 10:29:42 am

Nice cutting

Title: Re: Fisherman plaque
Post by: Marcellarius on October 19, 2012, 08:36:02 am

nice job!