Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: Tomsunnu on July 30, 2012, 09:40:46 am

Title: Portrait of Christ
Post by: Tomsunnu on July 30, 2012, 09:40:46 am

My very first attempt  :) Took quite a long to finish it(i think!!)
all comments are very welcome :). From a sketch found on the net.
Thanks
Mahendra

Title: Re: Portrait of Christ
Post by: mickey357 on July 30, 2012, 05:38:33 pm

Like the pattern. I don't anything about making a pattern,is there a way to smooth out the lines for easier cutting?

Title: Re: Portrait of Christ
Post by: newfie on July 30, 2012, 06:58:21 pm

nice pattern thanks for sharing

Title: Re: Portrait of Christ
Post by: Tomsunnu on July 31, 2012, 01:02:03 am

Quote from: mickey357 on July 30, 2012, 05:38:33 pm

Like the pattern. I don't anything about making a pattern,is there a way to smooth out the lines for easier cutting?

Yes, i have been trying to make those lines crisp but there are still tools in the program that I am not aware of :) I am sure some of the senior members will guide me in correcting this .
Thanks
Mahendra

Title: Re: Portrait of Christ
Post by: frankorona on July 31, 2012, 08:01:28 am

Very nice pattern, thanks for sharing

Title: Re: Portrait of Christ
Post by: Keefie on July 31, 2012, 04:00:15 pm

Even if the lines aren't crisp , it's still a great pattern. Thanks for sharing

Title: Re: Portrait of Christ
Post by: jlatorre on July 31, 2012, 06:51:58 pm

very nice pattern