Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: jackrabbit7822 on July 25, 2012, 02:46:50 pm

Title: font mentioned in first instructions
Post by: jackrabbit7822 on July 25, 2012, 02:46:50 pm

in the first set of instructions you mentioned a font to make a fancier name plate either i miss understood the name which I think was dolf . but try as i may i can't seem to find it in the available fonts.

Thank You
Jack Fleming ???

Title: Re: font mentioned in first instructions
Post by: don in brooklin on on July 25, 2012, 03:50:44 pm

I have been testing the new program and it is cool.  You can do anything that you can do with the original programs.

key chains
   font:    mychain
Note:  start with .  end with /
       Special stuff   Dog bone start [  end ]
                            heart is , and star is ;

name plates
font:  Scrollsaw    start wing is .  end wing is /

Note Scrollsaw02 and 03 can be used for name plates too.


oval key chain

use any stencil font

Don

Title: Re: font mentioned in first instructions
Post by: spiderman on August 02, 2012, 02:39:26 am

have you try the newest version .4