Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: cdrover(Clyde) on June 03, 2012, 07:33:53 pm

Title: my first try
Post by: cdrover(Clyde) on June 03, 2012, 07:33:53 pm

This is my first attempt at Ron Brown's sliding silhouette. It was for my grandaughter, took about 10 minutes to cut. I can see ways to improve.

Title: Re: my first try
Post by: Tomsunnu on June 03, 2012, 10:21:48 pm

Nicely done! Looks great :)

Title: Re: my first try
Post by: DWSudekum on June 03, 2012, 11:03:38 pm

Looks pretty good for a first try.  Thanks for sharing it with us.

DW

Title: Re: my first try
Post by: frankorona on June 04, 2012, 07:44:58 am

Very nice job, thanks for sharing

Title: Re: my first try
Post by: Russ C on June 04, 2012, 07:55:30 am

Good job, nice work.  :)

Title: Re: my first try
Post by: newfie on June 04, 2012, 11:42:03 pm

looks good to me Clyde.where you get the pattern at?

Title: Re: my first try
Post by: Keefie on June 05, 2012, 05:49:17 pm

looks very good to me too.

Title: Re: my first try
Post by: chelcass on June 05, 2012, 06:30:08 pm

Looks really good to me also.

Title: Re: my first try
Post by: daliclimbs on June 06, 2012, 09:23:05 am

Looks pretty good to me!

Title: Re: my first try
Post by: Marcellarius on June 07, 2012, 03:47:57 pm

nice job, always time for a 10 minute job  ;).