Scrollsaw Workshop Community -Please register to enable posting.
General Category => Ask Steve a question. => Topic started by: dwssr2 on August 14, 2016, 06:18:33 pm
-
Hi Steve, I have a question about your nativity pattern, the older one "Mantle Nativity Display" the pattern I printed out the measurements for the roof and the sides are listed on the pattern, but the printed pattern is slightly smaller. Could I have made a mistake printing or are the measurements just nominal? I am making one of these for a Christmas gift. Thanks for any help. dan in Pa
-
I suspect you can solve the problem by simply adjusting the print size (usually expressed as percentages) on your print screen options when you print the pattern.
Dennis