Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: dwssr2 on August 14, 2016, 06:18:33 pm

Title: Pattern question
Post by: dwssr2 on August 14, 2016, 06:18:33 pm

Hi Steve, I have a question about your nativity pattern,  the older one "Mantle Nativity Display"  the pattern I printed out the measurements for the roof and the sides are listed on the pattern, but the printed pattern is slightly smaller.  Could I have made a mistake printing or are the measurements just nominal?  I am making one of these for a Christmas gift.   Thanks for any help.   dan in Pa 

Title: Re: Pattern question
Post by: Dennis123 on August 16, 2016, 08:47:02 am

I suspect you can solve the problem by simply adjusting the print size (usually expressed as percentages) on your print screen options when you print the pattern.

Dennis